Sea-Doo Onboard

Sea-Doo Onboard

Tag Archives: battery charger

HOW-TO WITH DOCTOR DOO: SEA-DOO WINTERIZING TIPS – KEEP UP THE ENERGY

25 Tuesday Nov 2014

Posted by Sea-Doo OnBoard Editor in "How-To" Series, Doctor Doo

≈ Leave a comment

Tags

battery, battery charger, best, dealership, DIY, doctor doo, gti, gtx, how to, maintenance, performance, reliable, rxp, Sea-Doo, service, show me, Spark, technician, tips, wake, watercraft, website, winterizing

drdoo Dr. Doo wants you to keep your energy up during the offseason so your Sea-Doo watercraft is in tip-top shape when spring arrives.

This monthly blog will include tips and insight on seasonal maintenance, systems care, and the products to help maximize your Sea-Doo Life. The winter cold is tough on batteries. It’s important to take the proper preventive maintenance steps to ensure your battery is healthy and ready-to-go when you take your watercraft out of hibernation.

The cold can cause troubles for your battery trauma in two ways;

  • Your Rotax engine requires much more current from your battery to turn over when it’s cold due to the thickening of the oil.
  • Colder temperatures slow the chemical reactions that generate electricity.

Although you may not be using your Sea-Doo watercraft in the cooler months as often, or at all, these tips from Dr. Doo will help ensure you keep the energy up with your electrical system. 

Give your battery a visual check-up.

Ensure your Sea-Doo battery terminals are corrosion free.

Ensure your Sea-Doo battery terminals are corrosion free.

Take a detailed look at the battery casing, looking for damage such as cracks or leaks. If you find any “flaws” in the battery, replace it immediately as a damaged battery can cause operational problems. The battery terminals (where the cables attach to the battery) should be clean, free of corrosion and the cable ends should be securely attached with no “wiggle.” Also, check the cables themselves for damage or wear. If there is any exposed metal of the wiring, replace that section.

Conduct a test.

A certified BRP Sea-Doo watercraft technician should check any battery three years old or older. The tech can conduct a cold cranking power test (CCA test) to measure the amount of power (amperage) the battery is able to produce for half a minute in cooler temperatures. A battery should produce a minimum voltage of 7.3 volts even at freezing. If the battery falls below these minimum standards, it’s time to purchase a new Yuasa° battery from an authorized BRP/Sea-Doo dealer.

Keep it warm if possible.

Providing a protected environment away from freezing temperatures and frigid winds can help keep the energy levels up. If possible, store your watercraft inside a garage or closed storage area. If storing your Sea-Doo watercraft inside isn’t possible you may want to consider removing your battery and storing it in your garage during the winter. When storing your battery, be sure to cover your terminals with a rubber cover or in a cardboard box to avoid possible arcing.

A "Smart" battery charger will maintain proper charge over extended times of non-use.

A “Smart” battery charger will maintain proper charge over extended times of non-use.

An IV for your battery.

To help ensure your battery maintains healthy energy levels Dr. Doo prescribes you utilize a smart battery charger. These tools are designed for this use and won’t overcharge your battery and ensure they are at maximum strength when it’s go time. These tools can also be used for your other motorized vehicles that utilize a 6-volt or 12-volt system.

Drdoo-levelKeeping up the energy during the long winter months is challenging but with Dr. Doo’s How-To tips to live the best Sea-Doo Life, your watercraft battery will receive a complete clean bill of health.

2016

DOCTOR DOO – Keeping Your Battery Charged

26 Wednesday Dec 2012

Posted by Sea-Doo OnBoard Editor in Doctor Doo

≈ 9 Comments

Tags

battery charger, bayliner boats, boat brands, boat prices, fast boats, fishing boats, how to winterize, how to winterize a jetski, jet boats, jet ski, jetski, jetskis, kawasaki jetski, motorboating, personal watercraft, pwc, sea doo dealers, Sea-Doo, sea-doo jetski, seadoo, seadoo boats, seadoo dealers, seadoo jetski, seadoo waverunner, seadoos, speed boats, sport boats, stand up jetski, waverunner, winterization, winterizing your seadoo, yamaha waverunner

Many of you have already stored your Sea-Doo for the winter, or are in the process of storing your Sea-Doo.  A very important aspect of winterization is battery maintenance.  Proper storage techniques can be make the difference between a dead battery or a battery that roars to life after a long winter’s slumber.

Reasons for keeping a constant charge

– It keeps the battery from being depleted from non-use.

– Help maintain battery life

– Battery is ready when you go to de-winterize your Sea-Doo watercraft.

Tools needed

–       Phillips head screwdriver, Flat head screw driver or 10mm nut driver

–       Trickle Charger (Sea-Doo carries the Yuasa smart shot automatic battery charger, part # 529035773. See your local dealer for details)

Important Note

–       Never charge or boost battery while installed in the watercraft

–       Always charge a battery in a well vented room

–       Always make sure trickle charger or battery charger is unplugged before connecting charger cables or before removing charger cables.

Instructions 

1.  Locate the battery in your Sea-Doo watercraft.

2.  Next take a look at the bolts that secure your battery cables to the battery and determine what tool must be used to remove the cables.

3.  Be sure to remove the negative (-) black cable first and make sure it does not come in contact with the battery or any other grounding component (such as any exposed hardware) during the next steps.

4.  Remove the positive (+) red cable from the battery.

5.  Disconnect the vent hose from battery.

6.  Install a piece of hose (same type as vent hose) with a cap or a small hose pincher onto the battery to prevent electrolyte spillage when removing the battery.

7.  Remove any straps or brackets that may be securing the battery into the battery tray.

8.  Remove the battery and place it on a workbench or something comparable. Be sure to place it out of the reach of children.

9.  Make sure your trickle charger is unplugged and then connect the charger to the battery, making sure the positive (+) red cable is hooked up to the positive end on the battery and the negative (-) black cable is hooked up to the negative end of the battery.

10.  Plug in the charger to a wall socket and you are ready to stay charged!

Additional instructions – If the battery terminals seem to have corrosion or rust of any sort, use a wire brush to remove before connecting to the charger.

The best way to maintain proper battery life is to keep a constant charge, so keep up on your battery maintenance to maintain that showroom like quality all year round.

 

 

Subscribe

  • Entries (RSS)
  • Comments (RSS)

Archives

  • June 2018
  • April 2018
  • March 2018
  • February 2018
  • November 2017
  • October 2017
  • April 2017
  • October 2016
  • September 2016
  • August 2016
  • June 2016
  • May 2016
  • April 2016
  • March 2016
  • February 2016
  • January 2016
  • December 2015
  • November 2015
  • October 2015
  • September 2015
  • August 2015
  • July 2015
  • June 2015
  • May 2015
  • April 2015
  • March 2015
  • February 2015
  • January 2015
  • December 2014
  • November 2014
  • October 2014
  • September 2014
  • August 2014
  • July 2014
  • June 2014
  • May 2014
  • April 2014
  • March 2014
  • February 2014
  • January 2014
  • December 2013
  • November 2013
  • October 2013
  • September 2013
  • August 2013
  • July 2013
  • June 2013
  • May 2013
  • April 2013
  • March 2013
  • February 2013
  • January 2013
  • December 2012
  • November 2012
  • October 2012
  • September 2012
  • August 2012
  • July 2012
  • June 2012
  • May 2012
  • April 2012
  • March 2012
  • February 2012
  • January 2012
  • December 2011
  • November 2011
  • October 2011
  • September 2011
  • August 2011
  • July 2011
  • June 2011

Categories

  • "How-To" Series
  • 2012 Club BRP Coverage
  • 2017 Sea-Doo Watercraft
  • 2018 Sea-Doo Watercraft
  • Behind the scenes
  • Contest Rules
  • Doctor Doo
  • Events
  • Media Reviews
  • MUST HAVE OF THE WEEK
  • Questions of the Month
  • Sea-Doo Clean Sea
  • Sea-Doo Lifestyle
  • She-Doo
  • Technologies
  • The Intrepid Cottager
  • Ultimate Sea-Doo Fan
  • Uncategorized
  • Where to Ride
  • X-TEAM Profile

Meta

  • Register
  • Log in

Blog at WordPress.com.

  • Follow Following
    • Sea-Doo Onboard
    • Join 119 other followers
    • Already have a WordPress.com account? Log in now.
    • Sea-Doo Onboard
    • Customize
    • Follow Following
    • Sign up
    • Log in
    • Report this content
    • View site in Reader
    • Manage subscriptions
    • Collapse this bar
 

Loading Comments...